Touch screen programmable room thermostat BHT1000/W - for infrared heating film
Availability: In stock
Only 4 left
Manual wire thermostat with LCD screen BHT1000/W, used to control electric floor heating systems or electric heaters. The thermostat has an incorporated room temperature sensor and a wire floor temperature sensor NTC. Intuitive room temperature programming (5 + 2) or manual control. Used for underfloor heating, heating foils, heating panels, heating mats.
The thermostat is equipped with a built-in air temperature sensor and an attached external floor temperature sensor. The thermostat can control both the room temperature and the floor temperature.
When a thermostat is used in underfloor heating, the thermostat switches on the heating system to achieve the desired room temperature while not allowing the floor temperature to be exceeded, thereby protecting the floor against excessive heat.
When using a thermostat for electric heaters, only the built-in air temperature sensor is used.
Power supply 230 V AC. Max. Load 16 A (3600 W)
Touch screen programmable room thermostat BHT1000/W with floor and room temperature sensor for infrared heating mats (film)
Operating modes of the thermostat:
In- temperature control via internal sensor. The built-in air temperature sensor controls the room temperature while the floor sensor is off. This mode is used in all types of electrical heating, except underfloor heating
Out- Temperature control via external sensor. The external NTC temperature sensor controls the floor temperature while the room air sensor is off. This mode is used in underfloor heating to control only the floor temperature.
All – built-in air temperature sensor controls the room temperature and the floor sensor limits the floor temperature. Mode used in electric underfloor heating.
Acrylic front panel
Large backlit display
Elegant chrome frame
Temperature programming in cycles 5+2
The internal and external sensors allow you to control both the air temperature and the floor temperature.
Suitable for installation in a standard 60mm round box
Installation method: flush-mounted – in the installation box
Warranty: 18 months
Hystersis: range from 0°C to 5°C
Floor temperature range：10-70℃
Room temperature range: 5-35℃
2 sensors: incorporated room temperature sensor + floor temperature sensor NTC
Level of protection: IP20
Maximal output. 16 A, 3600 W
Power supply: 95~240 VAC, 50~60Hz
Floor heating with HEAT DECOR heating film
Electric appliances with a voltage of 230 V controlled by on/off switch
The kit contains:
Thermostat with incorporated room temperature sensor
Wire floor temperature sensor NTC
Montage screws , English instruction
Write Your Own Review